Difference between revisions of "ThermoPad FW Update"
Jump to navigation
Jump to search
| Line 1: | Line 1: | ||
# Download and install the SUB-20 Driver and Package:<br>[http://www.xdimax.net/download/SUB-20-driver-120622-x64.exe SUB-20 Driver]<br>[http://www.xdimax.net/download/SUB-20-151016.exe SUB-20 Package]<br> | # Download and install the SUB-20 Driver and Package:<br>[http://www.xdimax.net/download/SUB-20-driver-120622-x64.exe SUB-20 Driver]<br>[http://www.xdimax.net/download/SUB-20-151016.exe SUB-20 Package]<br> | ||
| − | # Download and install the CoolAutomation SW Package:<br>[http://coolautomation.com/lib/utilities/update-utility/CoolAutomation- | + | # Download and install the CoolAutomation SW Package:<br>[http://coolautomation.com/lib/utilities/update-utility/CoolAutomation-170810.exe CoolAutomation SW Package] |
# Connect XDIMAX programmer box to PC with USB cable | # Connect XDIMAX programmer box to PC with USB cable | ||
# Connect IR emitters cord to programmer and place IR emitters on the ThermoPad's touch screen | # Connect IR emitters cord to programmer and place IR emitters on the ThermoPad's touch screen | ||
Revision as of 08:04, 26 December 2017
- Download and install the SUB-20 Driver and Package:
SUB-20 Driver
SUB-20 Package - Download and install the CoolAutomation SW Package:
CoolAutomation SW Package - Connect XDIMAX programmer box to PC with USB cable
- Connect IR emitters cord to programmer and place IR emitters on the ThermoPad's touch screen
- From Windows Start Menu Run CoolAutomation -> TSUpdater
- Load ThermoPad FW image:
- Power up ThermoPad and while in Boot mode, press the 'Start Update' button on TSUpdater tool. ThermoPad Boot mode screen is shown below. ThermoPad will stay in Boot mode for 5sec after power up or reset.
- Wait until update is done and disconnect the IR emitters
- Set calibration and defaults on ThermoPad (see ThermoPad PRM)
